RESIDENTIAL HVAC · MARTINEZ, CA

Residential HVAC & Heat Pumps in Martinez, CA

From Victorians near the waterfront to ranches off Alhambra Avenue, Martinez homes vary widely. We design heat pump systems to fit the house, whether that means ductless heads in plaster-walled rooms or a ducted system in an attic.

Remodels · Retrofits · Heat Pumps · Multi-Zone Systems

Project Inquiry

Plan your Martinez project

Share your project type, ZIP, timeline, and how to reach you. We will follow up.

We design and install complete systems in the East Bay, San Francisco and Marin. We do not do repair, service calls or maintenance.

  • 5.0 Google Rating 5.0 out of 5 stars
  • Mitsubishi Electric Diamond Contractor
  • C-20 + C-36 Licensed & Bonded
  • Serving the Bay Area since 2015

Example multi-zone retrofit

Whole-home heat pump remodel

View project →
Mitsubishi wall unit in a Berkeley remodel by 3rdGen
Mitsubishi wall unit in a Berkeley remodel by 3rdGen
Mitsubishi hanging outdoor units in a Berkeley remodel by 3rdGen

High-end residential remodel

Hearst Remodel

This is a Berkeley remodel, not a Martinez job. It shows how we handle multi-zone ductless retrofits and refrigerant routing in an existing home.

Home type
Existing home, remodel for sale
System
Fujitsu multi-zone ductless heat pump
Mechanical scope
  • · Six indoor wall units
  • · Two outdoor units
  • · Wall-mounted outdoor brackets
  • · Refrigerant routing and field coordination

Challenge

  • Existing older home with limited equipment placement options
  • Outdoor units required side-yard wall bracket mounting
  • Finish-sensitive interior installation
  • Coordination with the general contractor’s remodel schedule

3RDGEN scope

  • Six-zone ductless heat pump installation
  • GC-led remodel coordination
  • Permit and inspection support
  • Startup as part of the completed remodel scope

Outcome

The six-zone Fujitsu ductless system was installed, permitted, inspected, and completed as part of the home’s remodel-for-sale scope — delivering zoned heating and cooling without a conventional ducted retrofit.

Representative example from a Berkeley, CA remodel, not a project in this city. Photos and full details on the project page.

View project

Local projects

Heat pump & HVAC installs for Martinez homes

Recent installs by the 3rdGen crew that serves Martinez: ducted and ductless heat pumps, air handlers and ductwork.

Wall-mounted ductless head in a warm, finished living room
Residential heat pump condenser on a slate patio beside the house
Outdoor condenser mounted on a concrete pad against gray siding
Gas furnace and air handler with coil in a tidy utility closet
Outdoor heat pump condenser unit installed in a garden bed beside a wooden fence
Horizontal air handler hung in a crawlspace with insulated ductwork and a drain line

Old houses, new equipment

In Martinez, the age of the house decides whether ducts are even an option

The older neighborhoods around downtown have houses from the late 1800s to the 1930s. Many were never built for central air. They have balloon framing, raised floors, little insulation and heat from a wall furnace or an aging gravity system.

That is where ductless and concealed multi-zone systems often make sense. Our Manual J accounts for uninsulated walls and old windows, Manual S selects equipment for Martinez’s 35°F and 92°F design points, and Manual D is used only where ducts truly fit.

Away from downtown, mid-century homes have more conventional attic duct systems. There the work is mainly testing, sealing and replacing equipment correctly.

  • Uninsulated historic walls

    Walls and floors with little insulation raise heating loads. We account for what we find and recommend upgrades where they make sense.

  • Preserving trim and plaster

    Careful routing keeps cuts small and hides line sets, so historic character stays intact.

  • Facade-facing equipment

    We place outdoor units on side or rear elevations and show you the plan before work.

  • Valley and hill properties

    Longer driveways and detached buildings call for different layouts, sometimes separate systems for outbuildings.

HVAC in Martinez

Martinez mixes century-old downtown houses with mid-century neighborhoods, and each needs its own approach

Martinez is the Contra Costa County seat on the Carquinez Strait. Around the historic downtown, you find Victorians, bungalows and craftsman homes with balloon framing and no ducts. Out toward Vine Hill and Alhambra Valley, the housing is newer and spread out. We plan heat pumps differently for each.

Design climate · Title 24 Climate Zone 12
Winter design temp
35°F
Summer design temp
92°F

Martinez design conditions are about 35°F for winter, one of the milder numbers among inland Contra Costa cities, and 92°F for summer. Delta breezes off the strait cool many evenings, and the daily range is wide at about 36 degrees. That favors variable-speed equipment and homes that can use night cooling.

ACCA Manual J design data · Martinez FS (ACCA micro-climate)

The range of Martinez houses

Historic Martinez homes are often wood-frame houses from the late 1800s through the 1930s with raised foundations, tall ceilings, plaster walls and little or no insulation. Many have only wall furnaces or an old gravity system. Ducts, if they exist, were added later and are often awkward.

Mid-century neighborhoods have single-story ranches and split-levels with attic ducts and central AC. These are more conventional, but their equipment is often decades old.

Larger parcels in the valley and hills have long driveways, sometimes well water and detached outbuildings that can host guest units. Wildfire and refinery smoke, plus summer heat, make filtration worth planning.

No ducts in a Victorian

With tall ceilings and plaster walls, adding ducts means finding chases. We frequently recommend ductless or slim ceiling-recessed heads for historic rooms, and keep any ductwork to attics or basements where it can be hidden.

Manual J for uninsulated walls

Old walls with no insulation and single-pane windows push heating load up, so the calculation is sensitive to what is in the walls. We note what we can verify and treat unknowns conservatively.

Delta breeze and wide temperature swing

A 36-degree daily range means the system works hard in the afternoon and idles by night. We match Manual S to part-load operation as well as peak demand.

Preserving historic character

Outdoor unit location and line-set routes are chosen to stay off the street-facing facade. We show you the plan before work starts.

Smoke and refinery air

When smoke or industrial odors come through the valley, a better filter and controlled ventilation make a real difference. We make space for both in the air handler design.

  • Ductless systems for historic homes

    Slim heads and concealed line sets that avoid cutting into plaster and trim.

    Ductless & multi-zone →
  • Wall-heater and gravity-furnace replacement

    Retire an old gas wall unit or gravity furnace and heat and cool the home with a heat pump.

    Replacement & conversion →
  • Ranch and split-level ducted replacement

    Replace an old furnace and AC with a ducted heat pump on tested attic ducts.

    Heat pump installation →
  • Historic remodel mechanical planning

    Equipment and routing designed alongside renovations while walls are open.

    HVAC for remodels →
  • Guest house and outbuilding HVAC

    Compact heat pumps for ADUs, studios and converted outbuildings.

    ADU heating & cooling →
  • Rebate and incentive help

    We tell you which programs might apply to your project.

    Rebates →
  • Diamond Contractor installs

    Mitsubishi-certified installation with extended coverage on qualifying systems.

    Diamond Contractor →

Permits, MCE and incentives in Martinez

HVAC permits in Martinez go through the City of Martinez Building Division. Homes in the historic downtown may also face design considerations for exterior changes, so we show equipment locations on the site plan and keep them off principal facades when possible.

Martinez is an MCE Clean Energy community, with PG&E handling delivery. State and local heat pump incentives, including TECH Clean California and BayREN programs, change over time. We check what is open when we quote, and we do not promise amounts.

Where we work in Martinez

Historic downtown and the waterfront area, the neighborhoods around Alhambra Avenue, Vine Hill and Alhambra Valley, plus Pleasant Hill, Concord and Benicia across the strait.

Homeowner reviews

Trusted by Bay Area Homeowners

5.0
5 out of 5 stars from 207 Google reviews

207 Google reviews

  • Mitsubishi Electric outdoor heat pump installed on a concrete pad at a Bay Area home Expand
    Mitsubishi mini-split installed with outstanding care. Indoor and outdoor units done right. High efficiency meant a meaningful federal tax credit too.
    Gary Marks Google review
  • Mitsubishi Electric Smart Multi outdoor unit wall-mounted on a residential exterior Expand
    Devin and his crew did a fantastic job installing AC for our whole house. High quality Mitsubishi equipment and a clean installation throughout.
    Christian Vuerings Google review
  • Mitsubishi Electric air handler installed in an insulated attic with sealed duct connections Expand
    Devin is meticulous, methodical, and knowledgeable. Professional crew and a heat pump install we trust completely.
    D C Google review

Photos from the installs above

Read all 207 reviews

How a Martinez project goes

Careful planning for houses with history

Older houses hold surprises, so we plan around what we can see and verify before committing to a design.

01 — Condition survey

We look at the framing, attic, basement or crawlspace, panel and exterior to learn what can be routed where.

02 — Manual J

Loads calculated with verified wall, ceiling and window details, and conservative assumptions where unknown.

03 — Manual S and system type

We choose between ductless, ducted or mixed based on load, house and your goals, then select equipment.

04 — Manual D and permit

Where ducts fit, we design them. Then we submit a permit package to the City of Martinez Building Division.

05 — Installation

Old heaters removed, gas capped, line sets and ducts routed, and equipment set with minimal disruption.

06 — Commissioning

Charge, airflow and controls checked. We walk you through operation and maintenance.

Careful install

What a Martinez retrofit involves beyond the heat pump

In an older home, a heat pump install also means gas capping, patching, electrical work and careful routing. We plan each in advance.

The goal is a finished, tidy job that leaves historic details intact.

Tell us about the project
  • Heater removal

    Wall furnace or gravity unit taken out, gas capped, opening patched.

  • Concealed routing

    Line sets and ducts routed through attic, basement or closets.

  • Electrical

    Panel capacity checked and new circuits installed.

  • Commissioning

    Charge and airflow verified, controls explained.

Cost

What affects the price of a Martinez heat pump project

A historic house with a multi-zone ductless system and a mid-century ranch with attic ducts are different jobs. Number of zones, line-set routing, panel capacity, gas removal and patch work typically drive the cost more than equipment tier.

Ducted heat pump, existing ducts usable $20k–$30k Equipment tier, capacity, controls, condenser location and access
Ducted heat pump + duct repair or resizing $25k–$45k Amount of ductwork replaced, crawlspace or attic access, return-air changes
Ductless multi-zone, 3–4 heads $25k–$40k Head type, line-set length, routing, concealment and finish conditions
Whole-home ducted + ductless combination $40k–$80k+ Multiple systems, zoning, ductwork, filtration, ventilation and architectural coordination
New construction system $20k–$50k+ Building size, system count, Title 24/design requirements and coordination with the build
ADU system $10k–$15k Zone count, head type, line-set routing, and whether the ADU shares the main house or stands alone
Electrical panel upgrade, when required $10k+ Service size, meter location, utility requirements and site conditions

Prices as of November 2026. Complex whole-home and design-build projects can exceed these ranges. Rebates and incentives may reduce your net project cost.

Project inquiry

Planning HVAC work on a Martinez home?

Tell us about the age and type of house, what heats it now and what you would like to change. Photos help for older homes.

  • Reviewed by a project lead, not a dispatcher
  • We tell you if your scope is not a fit for us
  • No high-pressure in-home sales appointment

Project Inquiry

Send your project details

Project type, ZIP, timeline, and how to reach you.

We design and install complete systems in the East Bay, San Francisco and Marin. We do not do repair, service calls or maintenance.

Mitsubishi Electric

Proud Mitsubishi Electric Diamond Contractor

As a Mitsubishi Electric Diamond Contractor, we design and install ducted, ductless, and multi-zone systems for Bay Area homes, with factory-trained crews and longer warranty options on qualifying residential installs.

Mitsubishi is not automatically the answer to every home. We start with what the project requires and recommend the system that makes sense.

Mitsubishi Electric H2i hyper-heat outdoor heat pump units
Mitsubishi Electric Heating and Air Conditioning Mitsubishi Electric Diamond Contractor

12 Year Parts &
Compressor Warranty

12-year warranty

Extended parts & compressor coverage on qualifying Diamond installations.

Factory-trained crews

Ongoing manufacturer training on the latest hyper-heat systems.

Priority support

Direct factory escalation if anything ever needs attention.

FAQ

Common Questions

Answers for Martinez homeowners on historic houses, ductless options and permits.

My Martinez Victorian has no ducts. Can I still get air conditioning?

Yes. A ductless or multi-zone heat pump needs only small line sets. We route them through closets, attics or basements to keep plaster and trim intact.

How do you size a heat pump for uninsulated walls?

Manual J uses the actual construction. If we cannot verify what is in a wall, we use conservative assumptions and say so in the report.

Can the outdoor unit be hidden from the street?

Usually. We place it on a side or rear elevation, use brackets or a pad, and screen it where appropriate. We show the location before installation.

What does a permit involve in Martinez?

A mechanical permit from the City of Martinez Building Division, with load calculations and equipment data. Electrical work may need its own permit.

Who provides electricity generation in Martinez?

MCE Clean Energy provides generation and PG&E delivers it. We check current heat pump incentives when scoping a project.

We get smoke and industrial odors. Can the system help?

A higher-grade filter and sealed returns help, and ventilation such as an ERV lets you keep windows shut. We design space for these.

Do you handle detached garages and studios on larger lots?

Yes. A small heat pump sized to the structure’s own load is typically the cleanest fit.

Still have a question?

Tell us about your Martinez project

Discuss Your Project

Project Inquiry

Ready to Talk Through Your Martinez Project?

Tell us what you’re planning. We’ll review the project and follow up with the appropriate next step.

We design and install complete systems in the East Bay, San Francisco and Marin. We do not do repair, service calls or maintenance.

Project category
Project type
Timeline