Do I need ducts to heat my bungalow with a heat pump?
No. Ductless indoor heads connect through small line sets. Many raised-floor bungalows do well with ductless in living areas and a small ducted zone for bedrooms.
RESIDENTIAL HVAC · SAN ANSELMO, CA
San Anselmo houses are older, often remodeled in pieces, and sit in a valley that gets chilly nights and warm afternoons. We sort out what each house needs and install a heat pump that matches it.
Remodels · Retrofits · Heat Pumps · Multi-Zone Systems
Project Inquiry
Thanks — your project details are on their way to 3rdGen. We’ll review them and follow up about the next step.
Project fit
Craftsman bungalows, hillside houses and older homes with leftover duct work. This is what we usually do for them.
Raised floor
Ducted, ductless or a hybrid, chosen for houses with raised floors, plaster walls and little attic space.
Heat pump installationGas to electric
Old wall heaters and boilers replaced by a heat pump that also cools, with gas capped and patching done.
Replacement & conversionManual J
Loads calculated before and after envelope upgrades so you can see how much smaller the system can be.
Manual J load calculationsNew rooms
Heating and cooling for finished attics and added rooms without overloading the old system.
HVAC for remodelsSmall units
Compact mini-splits with separate thermostats for backyard cottages and garage units.
ADU heating & coolingClose neighbors
Low-sound units placed away from bedroom windows with vibration isolation.
Ducted and ductless optionsA published older-home project
High-end residential remodel
A Berkeley remodel of an older home, with six indoor units and wall-bracket outdoor units. It shows the kind of tight-site, finish-sensitive routing older San Anselmo houses can need.
The six-zone Fujitsu ductless system was installed, permitted, inspected, and completed as part of the home’s remodel-for-sale scope — delivering zoned heating and cooling without a conventional ducted retrofit.
Representative example from a Berkeley, CA remodel, not a project in this city. Photos and full details on the project page.
View projectLocal projects
Recent installs by the 3rdGen crew that serves San Anselmo: ducted and ductless heat pumps, air handlers and ductwork.
Valley houses
Older San Anselmo homes tend to have thin attic insulation, uninsulated floors and original windows. Those details drive the load. A Manual J run before and after improvements shows what each upgrade saves.
The valley holds cold air at night. ACCA lists about 33°F winter and 86°F summer design conditions, and we check heating output at that low point before choosing a unit.
Houses sit close together and many lots are tight. We choose quiet equipment and keep condensers away from bedroom windows and property lines. Outdoor unit position also considers the area’s flood history.
Crawlspace ducts need to be sealed and insulated, or replaced by ductless heads.
Slope, retaining walls and stairs limit where equipment can go.
Attic and floor insulation upgrades can shrink the required system.
Sound ratings and placement matter on narrow lots.
HVAC design in San Anselmo
San Anselmo’s older homes were built for gas heat and open windows. Many have been remodeled one room at a time, which leaves odd duct leftovers and mismatched insulation. A heat pump project here begins by sorting out what the house actually needs.
San Anselmo’s Manual J design temperatures are about 33°F in winter and 86°F in summer, with a daily range around 32°F. It is a valley, so cold air settles at night and warm afternoons are common. Heating and cooling both count here.
ACCA Manual J design data · San Anselmo (ACCA micro-climate)
Craftsman bungalows and early 20th century houses are common near downtown and in the flatter valley neighborhoods. Expect raised floors, plaster, limited attic space and original wall or floor heat.
Hillside streets rise quickly. Houses there sit on posts and retaining walls, with small yards and awkward places for outdoor equipment.
Many properties sit in the Ross Valley watershed and have a history of creek flooding, which is worth remembering when we choose where the outdoor unit goes.
A Manual D pass tells us quickly whether a raised-floor house can carry ducts at reasonable velocity. When it cannot, ductless heads in the main rooms and a small ducted zone for bedrooms is a practical split.
Attic and floor insulation are often the cheapest way to cut the load on an older house. We run Manual J before and after so you can see how much smaller the heat pump can be.
Because nights get cold, we verify heating output at the 33°F design point. Cold-climate inverter units hold capacity well at that temperature, so backup heat is rarely needed.
When houses sit close together, condenser sound carries. We pick quiet models, place units away from bedroom windows, and use vibration isolation.
Ducted, ductless or hybrid layouts picked for raised-floor houses with little attic space.
Heat pump installation →Remove gas wall heaters and older boilers and bring in a heat pump that also cools.
Replacement & conversion →A Manual J that compares your house as-is and after envelope improvements.
Manual J load calculations →Heating and cooling for finished attics, second stories and room additions.
HVAC for remodels →Compact heat pumps for backyard units and converted garages.
ADU heating & cooling →Factory-trained installation with extended coverage on qualifying systems.
Diamond Contractor →The Town of San Anselmo’s Planning and Building Department issues mechanical permits. We include the load report, equipment submittal and an outdoor-unit location drawing, and we note clearances to property lines. Fairfax and unincorporated areas nearby use their own jurisdictions.
MCE supplies generation service by default, with PG&E delivering power. Rebates from TECH Clean California, BayREN, MCE and PG&E come and go, so we check what applies when we quote and do not promise amounts.
The downtown valley, hillside streets and the neighborhoods around Sir Francis Drake Boulevard, plus Fairfax, Ross, Kentfield and San Rafael.
Homeowner reviews
207 Google reviews
Expand
Mitsubishi mini-split installed with outstanding care. Indoor and outdoor units done right. High efficiency meant a meaningful federal tax credit too.
Expand
Devin and his crew did a fantastic job installing AC for our whole house. High quality Mitsubishi equipment and a clean installation throughout.
Expand
Devin is meticulous, methodical, and knowledgeable. Professional crew and a heat pump install we trust completely.
Photos from the installs above
Read all 207 reviewsThe steps
We work from the envelope inward, so you buy the smallest system that does the job.
We look at the floor, attic, windows, current heaters and any planned work.
Loads calculated for the house today and with insulation or window upgrades, so you can compare.
Equipment and routing picked to the final load, with duct sizing or line set layouts.
Permit package with load report, equipment data and outdoor unit location.
Old heaters out, lines and ducts in, circuits added, patching completed.
Airflow, charge and controls tested and explained before the inspection closes.
What a retrofit covers
Retrofits in older houses involve more than the unit: patching, gas capping, electrical and drainage all have to be planned.
We test the system and teach you how to run it before we hand it over.
Tell us about the projectOld gas equipment removed and openings repaired.
Routed through the crawlspace, attic or walls as designed.
Capacity verified and new circuits installed.
Airflow, charge and controls checked and explained.
Cost
The difference between a small ductless job and a whole-house conversion is large. Crawlspace conditions, number of zones, patching after heater removal, panel work and hillside access shape the final number.
Prices as of November 2026. Complex whole-home and design-build projects can exceed these ranges. Rebates and incentives may reduce your net project cost.
Project inquiry
Share the age of the house, what heats it and any planned improvements.
Project Inquiry
Thanks — your project details are on their way to 3rdGen. We’ll review them and follow up about the next step.
Project teams
Older houses reveal surprises once walls open. We stay in touch with your builder so the HVAC plan adjusts as framing and wiring conditions come to light.
We work within existing project teams in San Anselmo and across Marin — or directly with homeowners when that is the right path.
Mechanical systems coordinated around architecture, ceiling conditions, equipment locations, routing, and finish requirements.
Explore HVAC for architectsClear scope, scheduling, rough-in coordination, submittals, inspections, startup, and project handoff.
Explore HVAC for builders & GCsField execution, equipment selection, controls coordination, submittals, installation, and commissioning aligned with the mechanical design.
Explore engineering coordinationAlready assembling your own project team? We can take ownership of the mechanical scope and coordinate directly with the other professionals involved.
Start a residential projectMitsubishi Electric
As a Mitsubishi Electric Diamond Contractor, we design and install ducted, ductless, and multi-zone systems for Bay Area homes, with factory-trained crews and longer warranty options on qualifying residential installs.
Mitsubishi is not automatically the answer to every home. We start with what the project requires and recommend the system that makes sense.
12 Year Parts &
Compressor Warranty
Extended parts & compressor coverage on qualifying Diamond installations.
Ongoing manufacturer training on the latest hyper-heat systems.
Direct factory escalation if anything ever needs attention.
FAQ
San Anselmo answers on bungalows, insulation, valley cold and noise.
No. Ductless indoor heads connect through small line sets. Many raised-floor bungalows do well with ductless in living areas and a small ducted zone for bedrooms.
It is worth pricing. Attic and floor insulation can reduce the load, and a smaller system costs less. We run Manual J both ways so you can see the difference.
Yes. Design low is about 33°F. Cold-climate heat pumps keep capacity at that temperature, and we confirm it during equipment selection.
We choose low-sound models and place them away from bedroom windows. Vibration isolation on pads or brackets reduces transmitted noise.
It can. In flood-prone areas we raise outdoor units and keep electrical connections high.
The Town’s Planning and Building Department issues the mechanical permit. Neighbors such as Fairfax use different jurisdictions.
MCE supplies generation and PG&E delivers it. Rebates from TECH Clean California, BayREN and utility programs change over time, so we confirm availability before quoting.
Nearby service areas
Project Inquiry
Thanks — your project details are on their way to 3rdGen. We’ll review them and follow up about the next step.